Bradford White · AeroTherm Series G2
Bradford White AeroTherm Series G2 error code 10
Superheat Fault
What it means
The control has detected an issue in the superheat stage of the refrigeration cycle, and the system may be too low in refrigerant.
Also listed in: Quick Service Guide, Heat Pump Water Heaters AeroTherm Series (Service Manual Supplement), 238-55219-00A, page 1
What Bradford White says to do
The manual gives no specific step for this code. Check the troubleshooting and maintenance sections on the AeroTherm Series G2 page, or call a qualified technician.
Last checked 2026-10-03.
Safety first
- WARNING: Turn OFF the electrical supply to the unit before installation and before removing any access panels to service the heater. (p.3, p.24)
- DANGER: Shut OFF power to the water heater before draining water to avoid electrocution. (p.29)
- CAUTION: For your safety, do NOT attempt to repair the water heater or any of its parts. Refer any repairs to a qualified service technician. (p.28)
From the manufacturer's manual for this series.
Other AeroTherm Series G2 codes
- 1 (Lower Temp Sensor - T1 fault)
- 3 (Lower Element Fault)
- 4 (Upper Element Fault)
- 5 (Control Fault)
- 6 (Supply Voltage Fault)
- 7 (Tank Over Temp Fault)
- 8 (Fan Fault)
- 9 (Compressor Fault)
- 11 (Airflow Restriction)
- 12 (Evap Outlet Sensor - T3B Fault)
- 13 (Evap Inlet Sensor - T3A Fault)
- 14 (Compressor Outlet Sensor - T4 Fault)
- 15 (Ambient Sensor - T5 Fault)
- 16 (Ambient Temp Hi/Lo)
- 17 (Compressor Hi Temp Fault)
- 18 (Water Leak Detected)
- 92 (Heating Relay Fault)
- 93 (Element Hard Fault)
- 94 (Condensate Fault)
- 95 (EEV Hard Fault)
- 96 (Superheat Hard Fault)
- 97 (Compressor Hard Fault)
- 98 (Fan Hard Fault)
- 99 (Upper Temp Sensor - T2 fault)